User's Manual

Arming / Disarming 13
Disarming a System in Alarm
Alarm Memory Display
When an alarm has occurred in your system, the Magellan console will store that alarm in its alarm memory. All zones where alarms
have occurred will be stored in the alarm memory. The system will erase the contents of the alarm memory every time the system is
armed. The Magellan console will indicate that there is an alarm in memory by illuminating the light and by displaying the
information symbol (see page 7) on the LCD screen. The alarm memory display can be viewed in two ways:
Through the Alarm Memory Menu
After an alarm has occurred
Fire Alarms
For complete coverage in residential units, smoke detectors should be installed in the following locations:
• In any hallway outside bedroom areas. Additional detectors should be installed for every bedroom area as shown in Figure 2 on page 14.
• On every floor of a multi-floor home or apartment.
• At both ends of a bedroom hallway if the hallway is more than 12m (40ft) long.
• At the bottom of a basement stairwell.
• At the top of the first to second floor stairwell and subsequent stairwells in multi-floored residential units.
User code
To disarm a system in alarm:
In the case of a burglar alarm, leave the premises immediately and call
the police from a safe location (i.e., neighbor’s).
Use the [PREV] or [NEXT] action keys to scroll through available events.
or
menu prev next
Use the [PREV] or [NEXT] action keys to scroll through available events.
or
prev nextok