User's Manual
Table Of Contents
- Things You Should Know
- Entering Programming Mode
- Installer Quick Keys
- Zone Programming
- Remote Control Button Programming
- System Timers
- On-board Programmable Outputs (PGMs)
- System Options
- Communicator Settings
- Report Codes
- System Settings
- Wireless Transmitter Assignment
- Wireless Output Assignment
- Wireless Keypad Assignment
- Wireless Repeater Assignment
- Wireless Programmable Output (PGM) Settings
- Wireless Supervision Options
- Wireless Repeater Options
- Appendix 1: PGM Event Table
- Appendix 2: Specifications
- Appendix 3: Connection Diagrams
- Power Connections
- Telephone Line Connections
- PGM Connections
- Hardwire Zone Connections
- Connecting the Radio Antenna (MG-6160 only)
- Connecting to a UIP-256
- X10 Transmitter Connections (MG-6160 only)
- Connecting Magellan to WinLoad
- Connecting a Paradox Memory Key (PMC-4)
- Tabletop Mounting
- Mounting Magellan on the Wall
- Appendix 4: Ademco Contact ID Report Codes
- Appendix 5: Automatic Report Code List
Magellan 21
Appendix 3: Connection Diagrams
Power Connections
Figure 2: Connecting the AC Transformer
Figure 3: Connecting the DC Power Supply
Figure 4: Connecting the Battery
Back view of the Magellan console.
Do not use any switch-
controlled outlets.
12Vac to 16Vac 1A
Insert the transformer’s wires
into the
AC terminals.
Back view of the Magellan console.
12Vdc to 18Vdc 1A
Insert the transformer’s wires into
the
AC and COMMON terminals.
+
-
DC Power
Supply
Back view of the Magellan console.
Insert the backup battery’s plug into the
connector labelled
BATT.
1.
Slide in the battery pack horizontally, tilt the battery pack
downward and then tuck it in Magellan’s battery compartment.
2.
3.
Snap in the battery compartment
cover when finished.
To order a battery pack, the battery
pack’s part number is:
Paradox #0780100178.