User's Manual
Table Of Contents
- Things You Should Know
- Entering Programming Mode
- Installer Quick Keys
- Zone Programming
- Remote Control Button Programming
- System Timers
- On-board Programmable Outputs (PGMs)
- System Options
- Communicator Settings
- Report Codes
- System Settings
- Wireless Transmitter Assignment
- Wireless Output Assignment
- Wireless Keypad Assignment
- Wireless Repeater Assignment
- Wireless Programmable Output (PGM) Settings
- Wireless Supervision Options
- Wireless Repeater Options
- Appendix 1: PGM Event Table
- Appendix 2: Specifications
- Appendix 3: Connection Diagrams
- Power Connections
- Telephone Line Connections
- PGM Connections
- Hardwire Zone Connections
- Connecting the Radio Antenna (MG-6160 only)
- Connecting to a UIP-256
- X10 Transmitter Connections (MG-6160 only)
- Connecting Magellan to WinLoad
- Connecting a Paradox Memory Key (PMC-4)
- Tabletop Mounting
- Mounting Magellan on the Wall
- Appendix 4: Ademco Contact ID Report Codes
- Appendix 5: Automatic Report Code List
22 Programming Guide
Figure 5: Auxiliary Output
Telephone Line Connections
Figure 6: Telephone Line Direct Connect
Figure 7: Line Plug Connection
Back view of the Magellan console.
13.8Vdc, 200mA Auxiliary Output
+-
Back view of the Magellan console.
To connect the telephone line
directly to the console:
1. Connect a RJ31X to the
R-1, T-
1,
RING and TIP terminals as
shown at right.
2. Connect the telephone
company wires and the home
telephone to the RJ31X.
Telephone Line Connection Note
The Magellan console must be able to seize the telephone line and place a
call in an emergency situation. It must be able to do this even if other
equipment (telephones, answering machines, computer modems, etc.)
already has the line in use. To do so, the Magellan console must be
connected to a properly installed RJ31X (or RJ38X) jack that is electrically
in series with and ahead of all other equipment attached to the same
telephone line. Proper installation is depicted in the diagram below. If you
have any questions concerning these instructions, you should consult your
telephone company or a qualified installer about installing the RJ31X (or
RJ38X) jack and the Magellan console for you.
Back view of the
Magellan console.
To connect the telephone line directly to the console:
1. Insert one end of the 4-pin RJ-11 cable into the line plug of the Magellan console.
2. Insert the other end of the RJ-11 cable into a standard telephone wall plug.
Do not connect
the RJ-11 cable
into this plug.