User's Manual

ManualsBrandsParadox Security Systems ManualsElectronicsWireless PIR detector

PMD2P-EI01 - Printed in Canada 06/2013

Specifications

FCC and Industry Canada Compliance Statement

This device complies with FCC Rules Part 15 and with Industry Canada license exempt RSS standard(s). Operation is subject to two

conditions:

(1) This device may not cause harmful interference

(2) this device must accept any interference that may be received or that may cause undesired operation.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée

aux deux conditions suivantes :

(1) l'appareil ne doit pas produire de brouillage, et

(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le

fonctionnement.

FCC ID: KDYMGPMD2P

IC: 2438A-MGPMD2P

FCC WARNING

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection agai nst harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and the receiver.

•Connect the equipment into an outlet different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this equipment not expressly approved by the party responsible for compliance (Paradox Security Systems Ltd.)

could void the user’s authority to operate the equipment.

Sensor Type Dual rectangular element

Coverage 88.5° - 11m (36ft) x 11m (36ft); Center beams: 15m (49ft)

Pet Immunity 18kg (40lbs)

RF Frequency 433 or 868 MHz with Magellan only

Lens 2nd generation Fresnel lens, LODIFF® segments

Walk Speed 0.2m to 3.5m/s (0.6ft to 11.5ft/s)

Battery Type & Life 3 x 1.5vDC “AAA” alkaline batteries; 2 years*

Current Rating 31uA standby / 15mA alarm

Transmitter Range 35m (115ft) with MG6130 / MG6160

70m (230ft) with MG5000 / MG5050 / RTX3; in a typical residential environment

Operating Temp. &

Humidity

0°C to 50°C (32°F to 122°F) / 5 to 90% max.

Dimensions & Weight 6.5 x 12.5 x 5.2cm (2.5 x 4.9 x 2.0 in) / 105 g (3.7 oz) with batteries

RF Immunity EN 50130-4: 10V/m 80MHz to 2.7GHz

Compatibility See paradox.com for compatibility details

Certification EN 50131 Grade 2 Class II; Certification body Intertek

* Battery life expectancy will vary according to the amount of traffic (movement) detected. Higher traffic levels will lower battery life.

Alive Software

To conserve the motion detector’s battery life, if the motion detector transmits two open zone signals (LED on for 3s) within a five-

minute period, the detector will fall into Energy Save Mode for approximately three minutes and will not transmit any alarm signals.

The red LED will continue to flash to indicate a detection. If the detector’s cover is removed and then replaced while in Energy Save

Mode, the first detection will trigger an alarm signal.

Walk-testing

To activate Walk-test Mode for three minutes, power up the detector or open and close the detector’s cover. With sensitivity set to

High (S2 = High), at 20°C, crossing more than one complete zone (consisting of two beams left and right sensor detecting elements)

with slow/fast walking or running should initiate an alarm. With sensitivity set to Low (S2= Low), the amount of movement required

to generate an alarm is doubled.

Beam Pattern

2.1m

(6.8ft)

(6.6ft)

(13.1ft)

(19.7ft)

(26.3ft)

10m

(32.8ft)

12m

(39.4ft)

14m

(45.9ft)

16m

(52.5ft)

12m

(39.4ft)

14m

(45.9ft)

16m

(52.5ft)

10m

(32.8ft)

10m

(32.8ft)

12m

(39.4ft)

14m

(45.9ft)

16m

(52.5ft)

88.5°

Warranty: For complete warranty information on this product, please refer to the Limited Warranty Statement found on the Web site www.paradox.com/terms. Your use of the Paradox product signifies

your acceptance of all warranty terms and conditions.

Patents: One or more of the following US patents may apply: 7046142, 6215399, 6111256, 6104319, 5920259, 5886632, 5721542, 5287111, and RE39406 and other pending patents may apply. Canadian

and international patents may also apply.