User's Manual

PARADOX.COM
Wireless Outdoor/Indoor
Window and Sliding Door
Dual Detector with
Anti-Masking and
Pet Immunity
NVR35M-EI01
General Description
The NVR35M module provides a superior wireless outdoor and indoor
solution for window and sliding door protection, with two operation
modes: Pet Immune Mode 7.5 x 2m (25 x 7 ft) and Sharp Mode (indoor use)
10 x 2m (33 x 7 ft) with dual verification detection.
Installing the NVR35M
1. Remove the front cover - open the Captive screw.
2. Remove the Main Unit: open the two snap-lock mechanisms on each
side of the back cover attaching the Main Unit to the back cover as
displayed below. Then remove the Main Unit.
3. Pull the wires from the control panel through the knockout holes and
mount the back cover onto the window frame or wall using screws..
4. Attach the Main Unit to the back cover - ensure the locks snap closed..
5. Insert two AA butteries.
6. Set DIP switch settings (see Table 1 below) according to requirements.
Figure 6 – Adjusting the settings
Table 1: DIP Switch Func tionality
* For USA and Canada: 433MHz frequency is set by the manufacturer and
cannot be modified.
7. Set Range/PIR Sensitivity level: Turn the Sensitivity Trimmer (see
Figure 6 above) to select the required level as displayed below..
Figure 7 – Sensitivity Trimmer
8. Replace the front cover and close the Captive screw.
Warning: Do not obscure the detector's field of view.
Testing the NV35MX
Perform a Walk-Test to test successful installation: Walk slowly across the
far end of the detection range. Ensure detection.
Walk test mode lasts 5 minutes after the tamper screw is closed.
Figure 1 – Removing the Front Cover Figure 2 – Main Unit
Figure 3 – Removing the Main Unit
Figure 4 – Mounting the Back Cover
Front
cover
Captive screw
Mounting
screw 1
Mounting
Tamper
screw 2
Tamper
knockout
hole
Knockout
holes
Figure 5 – Attaching the Main Unit
Dip Switch
Number
Function Mode Description
1LED
ON: Default
OFF:
2
PET Immunity/
SHARP Mode
ON: PET Immunity mode
OFF: SHARP mode
*3 RF
ON: 433MHz * (default)
OFF: 868MHz- applicable for EU
versions only
123
DIP switches
Sensitivity
trimmer
Default PIR Sensitivity level: 2
Note: After selecting the required
level, the LED flashes the number of
times equal to the level selected.
EXAMPLE: If level 2 is selected, the
LED flashes twice.
NVR35M
Installation Manual V1.0