Hotwire DSL Router User's Guide

C. Traps and MIBs
C-16 November 2003 6300-A2-GB20-10
Health and Status MIB
Objects supported by the Health and Status MIB, pdn_HealthAndStatus.mib,
include the following groups:
 Device Health and Status
 Device Selftest Status
 Device Abort Status
 Device Failure Status
 Traps
Table C-9. Device Status Group Objects Table
Object Description Setting/Contents
devHealthandStatus
(devStatus1)
This object displays alarm
messages if any alarms are
generated by the device.
Possible alarms are:
Alarm: Management Address Conflict.
Alarm: Failed Selftest.
Alarm: System Error.
No alarm is set.
devSelfTestResults
(devStatus 2)
This object corresponds to
self-test results. This value is used
as a binding for devSelfTestFailure
Trap.
P – Passed selftest.
F – Failed selftest.
devAbortStatus
(devStatus 3)
This object is used to retrieve the
latest abort status that is stored in
the agent.
Possible abort codes are:
INVALID_INTR
INT_TIMEOUT
O_YAMOS_FAILURE
INIT_NOBUFS
SYSCALL_FAILED
G_NO_BUF
G_BAD_CONFIG
G_NO_ABORT
devFailureStatus
(devStatus 4)
This object is used to retrieve the
latest failure status.
This value is used as a binding for the deviceFailure
trap.
devStatusTrapEnable
(devStatus 8)
Allows user to enable or disable
the selftest failure indication trap
and the device failure indication
trap individually.
Bit Sum.
1 – devSelfTest failure.
2 – device failure.
devStatusTestFailure Signifies that the sending
protocol’s device failed selftest.
The variable binding for this trap is the
devSelfTestResults object of the Health and Status
MIB.
deviceFailure Signifies that the sending
protocol’s device failed.
The reason for the failure was not selftest.