Hotwire DSL Router User's Guide

C. Traps and MIBs
C-20 November 2003 6300-A2-GB20-10
DSL Endpoint MIB
This DSL Endpoint MIB, pdn_DslEndpoint.mib, facilitates configuration of DSL
multirate products and is fully supported. Objects are clarified in Table C-12, DSL
Endpoint Configuration Group Objects Table. The groups in this MIB are:
 IP Routing Group – This table is an extension of the ipCidrRoute table (see
IP CIDR Route Group (RFC 2096) on page C-9).
 IP Multicast Group
 IP Processing Group
 Console Group
SYSLOG MIB
System Log MIB (SYSLOG), pdn_syslog.mib, is fully supported.
Interface Configuration MIB
The Interface Configuration MIB, pdn_IfExtConfig.mib, is used to configure
interface-related objects and is fully supported. One object is clarified below:
 pdn_IfExtConfigIPRoutedPDUs (pdnIfExtConfigEntry 1) – You can configure
the IP-routed PDUs in the LLC SNAP encapsulation or VC-based
Multiplexing encapsulation (RFC1483) in the upstream direction. If neither is
configured, the value none is used.
Table C-12. DSL Endpoint Configuration Group Objects Table
Object Description Setting/Contents
ipCidrRouteUpstreamNextHop
(IpCidrRouteXEntry 1)
Corresponds to the upstream Next
Hop Router address.
If the DSL interface is numbered,
each upstream Next Hop Router
address must be in a subnet
defined by a DSL interface
IP address and subnet mask.
Ethernet Interface IP address.
0.0.0.0 – No upstream next hop is
identified.
ipCidrRouteDownstreamValid
(IpCidrRouteXEntry 2)
If false, the row containing it is not
valid for downstream routing.
true
false
ipCidrClearAllRoutes
(IpCidrRouteX 2)
If set to clear, all IP routes are
removed from the routing table.
noOp
clear
ipCidrRouterID
(IpCidrRouteX 3)
Specifies the router ID (primary
IP address).
Must be equal to a nonzero value for the
interface IP address.
pdnlpMulticastEnable
(pdnRouterConfiguration 1)
Enables or disables forwarding of
IP multicast packets.
enable
disable
pdnlpProcessingEnable
(pdnRouterConfiguration 2)
Enables or disables service
domain processing of IP packets.
This setting is retained across power
cycles.
pdnConsoleEnabled
(pdnRouterConfiguration 7)
Enables or disables the console
port.
true(1) – Enable.
false(2) – Disable.