User's Manual

Using the Asynchronous Terminal Interface
2-2
8700-A2-GB20-00
April 2000
Logging In to the Hotwire DSLAM
You can log in to the Hotwire DSLAM system using either a local
VT100-compatible terminal or a remote Telnet connection.
After you enter your user ID and password, the system displays the Hotwire
Chassis Main Menu. See your management card documentation for information
about selecting the unit from the card selection screen.
Initiating an ATI Session
The Main Menu screen is displayed on the screen unless a login ID and
password is required or the ATI is already in use.
If security is enabled on the Hotwire Termination Unit and you used Telnet to
access it directly (you did not log in through the management card), the system
prompts you for a login ID and password.
Login
Slot: 4
Model: 87xx
LOGIN
Login ID:
Enter Password:
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions E
xit
If you enter an invalid login ID and password after three attempts, the Telnet
session closes or the terminal connection returns to an idle state. Refer to
Chapter 6, Security.
If the ATI is already in use, the message connection refused is sent to a
terminal attempting Telnet access.