Manual
Table Of Contents
- Contents
- About This Guide
- 1. About the FrameSaver SLV
- 2. User Interface and Basic Operation
- 3. Configuration Procedures
- 4. Configuration Options
- Using the Easy Install Feature
- Using RIP with FrameSaver SLV CSU/DSUs
- Entering System Information and Setting the System Clock
- Setting Up the Modem
- Setting Up Auto-Configuration
- Setting Up Dial Backup
- PVC Backup Over the Network Interface
- Setting Up Back-to-Back Operation
- Configuration Option Tables
- Configuring the Overall System
- Configuring Physical Interfaces
- Assigning Time Slots/Cross Connections
- Configuring Frame Relay for an Interface
- Manually Configuring DLCI Records
- Configuring PVC Connections
- Configuring the IP Path List
- Setting Up Management and Communication Options
- Configuring the Criteria for Automatic Backup
- 5. Configuring the FrameSaver SLV Router
- FrameSaver SLV Router Overview
- IP Routing
- Address Resolution Protocol
- Proxy ARP
- Interface Configuration
- Network Address Translation
- Network Address Port Translation
- Dynamic Host Configuration Protocol Server
- DHCP Relay Agent
- Router Security
- Provisioning the Router Interface
- Configuring the Router Using Terminal Emulation
- 6. Security and Logins
- 7. Operation and Maintenance
- 8. Troubleshooting
- 9. Setting Up OpenLane for FrameSaver Devices and Activating SLM Features
- 10. Setting Up NetScout Manager Plus for FrameSaver Devices
- 11. Setting Up Network Health for FrameSaver Devices
- A. Menu Hierarchy
- B. SNMP MIBs and Traps, and RMON Alarm Defaults
- C. Router CLI Commands, Codes, and Designations
- D. Router Command Line Summaries and Shortcuts
- E. Connectors, Cables, and Pin Assignments
- F. Technical Specifications
- G. Equipment List
- Index
5. Configuring the FrameSaver SLV Router
5-16
September 2002 9128-A2-GB20-80
Configuring the Router Using Terminal Emulation
The CLI is available via a Telnet session or a direct connection over the router’s
COM port to a VT100-compatible terminal or a PC running a terminal emulation
program. You access the CLI through the router’s menu-driven user interface.
From the Main Menu, press Shift-r to access the CLI.
Verify the required terminal settings:
Data rate is set to 19.2 Kbps (19200 bps).
Character length is set to 8.
Parity is set to None.
Stop bits is set to 1.
Flow control is set to Off or None.
Uploading and Downloading the Router Configuration Via the CLI
Use the
show configuration
command to output command strings needed to
restore the current running configuration.
Output from the show configuration command can be captured to a text file using
most terminal emulation programs. Once the text file is captured, the router can be
placed in configuration mode. The text file can then be fed back to configure the
router.