Manual
Table Of Contents
- Contents
- About This Guide
- 1. About the FrameSaver SLV
- 2. User Interface and Basic Operation
- 3. Configuration Procedures
- 4. Configuration Options
- Using the Easy Install Feature
- Using RIP with FrameSaver SLV CSU/DSUs
- Entering System Information and Setting the System Clock
- Setting Up the Modem
- Setting Up Auto-Configuration
- Setting Up Dial Backup
- PVC Backup Over the Network Interface
- Setting Up Back-to-Back Operation
- Configuration Option Tables
- Configuring the Overall System
- Configuring Physical Interfaces
- Assigning Time Slots/Cross Connections
- Configuring Frame Relay for an Interface
- Manually Configuring DLCI Records
- Configuring PVC Connections
- Configuring the IP Path List
- Setting Up Management and Communication Options
- Configuring the Criteria for Automatic Backup
- 5. Configuring the FrameSaver SLV Router
- FrameSaver SLV Router Overview
- IP Routing
- Address Resolution Protocol
- Proxy ARP
- Interface Configuration
- Network Address Translation
- Network Address Port Translation
- Dynamic Host Configuration Protocol Server
- DHCP Relay Agent
- Router Security
- Provisioning the Router Interface
- Configuring the Router Using Terminal Emulation
- 6. Security and Logins
- 7. Operation and Maintenance
- 8. Troubleshooting
- 9. Setting Up OpenLane for FrameSaver Devices and Activating SLM Features
- 10. Setting Up NetScout Manager Plus for FrameSaver Devices
- 11. Setting Up Network Health for FrameSaver Devices
- A. Menu Hierarchy
- B. SNMP MIBs and Traps, and RMON Alarm Defaults
- C. Router CLI Commands, Codes, and Designations
- D. Router Command Line Summaries and Shortcuts
- E. Connectors, Cables, and Pin Assignments
- F. Technical Specifications
- G. Equipment List
- Index
7. Operation and Maintenance
9128-A2-GB20-80 September 2002
7-81
Turning Off the System Alarm Relay
For carrier-mounted FrameSaver units, an alarm system relay is provided by the
9000 Series Access Carrier. This relay activates a light or buzzer when an alarm
condition is detected in one of the FrameSaver units.
Once the alarm relay is connected, enabling the System Alarm Relay option
activates this feature (see Table 4-5, General System Options, in Chapter 4,
Configuration Options
).
Once activated, the relay is turned off in one of the following ways:
The alarm condition that activated the relay no longer exists. The relay stays
on until all alarm conditions have been corrected.
The System Alarm Relay option can be disabled.
Main Menu
→
Configuration
→
System
→
General
System Alarm Relay Cut-Off can be selected.
Main Menu
→
Control
→
System Alarm Relay Cut-Off
See
Alarm Relay Connector
in the
9000 Series Access Carrier Installation
Instructions
for information about connecting the alarm relay.