User's Manual
Table Of Contents
- Contents
- About This Guide
- About the FrameSaver DSL Unit
- User Interface and Basic Operation
- Configuration Procedures
- Configuration Options
- Overview
- Using the Easy Install Feature
- Setting Up So the Router Can Receive RIP
- Entering System Information and Setting the System Clock
- Configuration Option Tables
- Configuring the Overall System
- Configuring the Physical Interfaces
- Configuring Frame Relay for the Data Port
- Configuring ATM for the Network Interface
- Configuring Circuit and DLCI Records
- Configuring PVC Connections
- Setting Up Management and Communication Options
- Configuring Node IP Information
- Configuring Management PVCs
- Configuring General SNMP Management
- Configuring Telnet and/or FTP Session Support
- Configuring SNMP NMS Security
- Configuring SNMP Traps
- Configuring the Ethernet Port
- Configuring the Communication Port
- Configuring the COM Port to Support an External Modem
- Security and Logins
- Operation and Maintenance
- FTP Operation
- Troubleshooting
- Setting Up OpenLane for FrameSaver Devices
- Setting Up Network Health for FrameSaver Devices
- Menu Hierarchy
- SNMP MIBs and Traps, and RMON Alarm Defaults
- Connectors, Cables, and Pin Assignments
- Technical Specifications
- Equipment List
- Index
FTP Operation
7-5
9783-A2-GB20-00
July 2000
Determining Whether a Download Is Completed
To see whether a download has completed, check the Identity screen.
Main Menu
→
Status
→
Identity
Check Alternate Software Rev. under the NAM Identity column.
H If a software revision number appears, the file transfer is complete.
H If In Progress appears, the file is still being transferred.
H If Invalid appears, no download has occurred or the download was not
successful.
Changing Software
Once a software upgrade is downloaded, it needs to be activated. When
activated, the unit resets, then executes the downloaded software. With this
feature, you control when the upgrade software is implemented.
" Procedure
To switch to the new software:
1. Go to the Control menu, and select Select Software Release.
Main Menu
→
Control
→
Select Software Release
The currently loaded software version and the new release that was just
transferred are shown.
If the download failed, Invalid appears in the Alternate Release field
instead of the new release number. Repeat the procedure in
Upgrading
System Software
if this occurs.
2. Select Sw
itch&Reset.
3. Enter Y
es to the Are you sure? prompt. The unit resets and begins
installing the newly transferred software.
4. Verify that the new software release was successfully installed as the Current
Software Revision.
Main Menu
→
Status
→
Identity
NOTE:
If someone opens a Telnet session and accesses the unit’s Identity
screen while the unit is downloading software, the In Progress...
message appears in the Alternate Software Revision field.
See
Displaying System Information
in Chapter 6,
Operation and
Maintenance
, to see what is included on the unit’s Identity screen.