User Guide

Security
4-5
7610-A2-GB20-10
November 1997
When user access to the ATI is attempted through the Terminal port or a Telnet
session, the ATI response is based on the Login Required option and the
availability of the ATI.
Table 4-2. ATI Access Conditions
If access to the ATI
is through the . . .
Then . . . What to do now?
Terminal port with
Security disabled with
the Login Required
option set to Disable.
(See Table A-4)
The Main Menu screen
appears.
Select a menu option to begin your
session.
Terminal port with
Security enabled with
the Login Required
option set to Enable.
(See Table A-4)
You are prompted for a
login ID and password.
If Invalid Password appears,
re-enter the password. After three
tries with an invalid password,
contact the system administrator.
(See Table A-4)
The Main Menu screen
appears if the login ID is
not configured yet.
Select a menu option to begin your
session.
Terminal port and the
ATI is already in use
with a Telnet session
User Interface Already
In Use
message appears
with the active user’s IP
address and Login ID.
Try again later. When the ATI is
available, the message User
Interface Idle
appears.
Telnet session and the
ATI is currently in use
Connection Refused
message appears. The
DSU allows only one
connection at a time.
Try again later.