User's Manual
Table Of Contents
- Contents
- About This Guide
- 1. About the FrameSaver SLV
- 2. User Interface and Basic Operation
- 3. Configuration Procedures
- 4. Configuration Options
- Using the Easy Install Feature
- Using RIP with FrameSaver SLV CSU/DSUs
- Entering System Information and Setting the System Clock
- Setting Up the Modem
- Setting Up Auto-Configuration
- Setting Up Dial Backup
- PVC Backup Over the Network Interface
- Setting Up Back-to-Back Operation
- Configuration Option Tables
- Configuring the Overall System
- Configuring Physical Interfaces
- Assigning Time Slots/Cross Connections
- Configuring Frame Relay for an Interface
- Manually Configuring DLCI Records
- Configuring PVC Connections
- Configuring the IP Path List
- Setting Up Management and Communication Options
- Configuring the Criteria for Automatic Backup
- 5. Configuring the FrameSaver SLV Router
- FrameSaver SLV Router Overview
- IP Routing
- Address Resolution Protocol
- Proxy ARP
- Interface Configuration
- Network Address Translation
- Network Address Port Translation
- Dynamic Host Configuration Protocol Server
- DHCP Relay Agent
- Router Security
- Provisioning the Router Interface
- Configuring the Router Using Terminal Emulation
- 6. Security and Logins
- 7. Operation and Maintenance
- 8. Troubleshooting
- 9. Setting Up OpenLane for FrameSaver Devices and Activating SLM Features
- 10. Setting Up NetScout Manager Plus for FrameSaver Devices
- 11. Setting Up Network Health for FrameSaver Devices
- A. Menu Hierarchy
- B. SNMP MIBs and Traps, and RMON Alarm Defaults
- C. Router CLI Commands, Codes, and Designations
- D. Router Command Line Summaries and Shortcuts
- E. Connectors, Cables, and Pin Assignments
- F. Technical Specifications
- G. Equipment List
- Index
4. Configuration Options
9128-A2-GB20-80 September 2002
4-105
When Auto Backup Allowed
Possible Settings: Always, Restrict
Default Setting: Always
Determines when backup for the access unit is allowed to occur.
Always – No restrictions on backup.
Restrict – Backup is restricted to the day and time selected in the following configuration
options. Use this selection when the importance of the data that you are backing up is
day/time dependent.
Backup Allowed:
Day
From
nn:nn
Possible Settings: 00:00 – 23:00, None
Default Setting: 00:00
Specifies the time that Auto Backup can begin for a selected day of the week in
increments of 1 hour.
Day
is Monday through Sunday.
00:00 – 23:00 – Specifies the time of day that Auto Backup will start for this particular day.
None – Auto Backup cannot occur on this day.
Backup Allowed:
Day
To
nn:nn
Possible Settings: 00:00 – 24:00
Default Setting: 24:00
Specifies the time that Auto Backup must end occurring for the selected day of the week in
increments of 1 hour.
Display Conditions
– This option only appears if a start time was specified.
00:00 – 24:00 – Specifies the time of day that Auto Backup will stop for this particular day.
Table 4-26. Auto Backup Criteria Options (2 of 2)