User's Manual
Table Of Contents
- Contents
- About This Guide
- 1. About the FrameSaver SLV
- 2. User Interface and Basic Operation
- 3. Configuration Procedures
- 4. Configuration Options
- Using the Easy Install Feature
- Using RIP with FrameSaver SLV CSU/DSUs
- Entering System Information and Setting the System Clock
- Setting Up the Modem
- Setting Up Auto-Configuration
- Setting Up Dial Backup
- PVC Backup Over the Network Interface
- Setting Up Back-to-Back Operation
- Configuration Option Tables
- Configuring the Overall System
- Configuring Physical Interfaces
- Assigning Time Slots/Cross Connections
- Configuring Frame Relay for an Interface
- Manually Configuring DLCI Records
- Configuring PVC Connections
- Configuring the IP Path List
- Setting Up Management and Communication Options
- Configuring the Criteria for Automatic Backup
- 5. Configuring the FrameSaver SLV Router
- FrameSaver SLV Router Overview
- IP Routing
- Address Resolution Protocol
- Proxy ARP
- Interface Configuration
- Network Address Translation
- Network Address Port Translation
- Dynamic Host Configuration Protocol Server
- DHCP Relay Agent
- Router Security
- Provisioning the Router Interface
- Configuring the Router Using Terminal Emulation
- 6. Security and Logins
- 7. Operation and Maintenance
- 8. Troubleshooting
- 9. Setting Up OpenLane for FrameSaver Devices and Activating SLM Features
- 10. Setting Up NetScout Manager Plus for FrameSaver Devices
- 11. Setting Up Network Health for FrameSaver Devices
- A. Menu Hierarchy
- B. SNMP MIBs and Traps, and RMON Alarm Defaults
- C. Router CLI Commands, Codes, and Designations
- D. Router Command Line Summaries and Shortcuts
- E. Connectors, Cables, and Pin Assignments
- F. Technical Specifications
- G. Equipment List
- Index
6. Security and Logins
6-8
September 2002 9128-A2-GB20-80
Limiting Telnet or FTP Access Over the TS Access Management Link
Procedure
To limit Telnet or FTP access when the session is
on
the TS Access Management
Link:
1. Select the Telnet and FTP Session options.
Main Menu
→
Configuration
→
Management and Communication
→
Telnet and FTP Sessions
2. Disable Telnet Session and/or FTP Session, as appropriate.
3. Return to the Management and Communication menu, and select Node IP.
4. Set the following configuration options, as appropriate.
5. S
ave your changes.
See
Configuring Telnet and/or FTP Session Support
or
Configuring Node IP
Information
in Chapter 4,
Configuration Options,
for more information about these
configuration options.
To . . . Set the configuration option . . .
Disable access via the TS
Access Management Link
TS Access Management Link to None.
Assign an access level to the
TS Access Management Link
TS Access Management Link’s Access Level to
Level-2 or Level-3.
NOTE:
Regardless of a user’s login access level, a
user cannot operate at a level higher than the
access level specified for the session (e.g., if a user
has a Level-1 login and Level-2 telnet access has
been set, the Level-1 user can only operate as a
Level-2 user).
If you are going to allow users to configure the unit,
keep the access at Level-1.