Operation Manual

1 Preface
1-2 FrameSaver NP 110 User’s Manual - Installation Guide 980-001-0240B
November
2000
Special
Instructions
The following are to be performed by qualified service personnel ONLY.
When installing FrameSaver NP 110 equipment, observe the following precautions:
1. Never install telephone wiring during a lightning storm.
2. Never install telephone jacks in wet locations unless a jack is specifically designed
for wet locations.
3. Never touch uninsulated telephone wires or terminals unless the telephone line has
been disconnected at the network interface.
4. Use caution when installing or modifying telephone lines.
WARNING
NO OPERATOR SERVICEABLE PARTS ARE INSIDE THIS
EQUIPMENT. SERVICE MUST BE PERFORMED BY QUALIFIED
SERVICE PERSONNEL.
ATTENTION
CET APPAREIL NE CONTIENT AUCUN EL
É
MENT QUE
L’UTILISATEUR PUISSE R
É
PARER. CONFEIR LA MAINTENACE
À
UN PERSONNEL TECHNIQUE QUALIFI
É
.
Do not expose the FrameSaver NP 110 to moisture, excessive heat or bright sunlight,
vibration, sudden impact, or voltage surges.
UNPACKING AND HANDLING
When you receive the equipment, inspect the exterior of the shipping container for
signs of obvious damage. If the container is damaged, inform the local carrier that
they may be subject to a claim.
As you unpack the equipment, check for physical damage and conformance to the
packing list. If the equipment is damaged or does not conform to the packing list,
please inform Paradyne Corporation immediately.
Avoid Moisture
Avoid Direct Sunlight/Heat
Avoid Vibration/Sudden Impact Avoid Voltage Surges