User's Manual

7. CONNECT TO POWER. Insert the supplied power cord’s

round end into the jack labeled POWER. Plug the

transformer into an AC outlet.

When the power cord is installed, the router goes through

a power-on self-test.

LED Status

on page 7 shows how

the LEDs should appear after a successful test.

Installation is now complete.

If your Internet Service Provider (ISP) has instructed you to configure the Hotwire

ADSL/R Bridge/Router using the web interface, or if you would like to use the device as

a router, proceed to

Configuring the Hotwire ADSL/R Bridge/Router

on page 8.

Note to service provider:

Each 6381 on the same subnet requires a unique IP address if

you wish to upgrade firmware or access it using the web interface.

POWER

Transformer