User's Manual

7
LED Status
The Hotwire ADSL/R Bridge/Router’s front panel includes LEDs (light-emitting diodes)
that provide status on the router and its interfaces. In Table 1, Front Panel LEDs, the
Condition in BOLD shows how the LED should appear after a successful power-on
self-test.
Table 1. Front Panel LEDs
LED Condition Status
PWR ON The router has power.
ALM ON
OFF
An alarm condition exists.
No alarms have been detected by the router.
TST ON
OFF
A service provider-initiated test is in progress.
No tests are active.
LINE ON
OFF
The DSL link is established.
No DSL link has been established.
TX/RX Blinking
OFF
Data transmission is in progress on the DSL line.
No data is being transmitted or received by the router.
ETHERNET ON
OFF
The Ethernet connection is active.
No Ethernet device is detected.
ADSL/R
TST
LINE ETHERNET
ALMPWR
TX/RX
03-17357