Gazebo GZ3XL Aluminium Composite Roof Panels Assembly Instructions 9’5’’ 7’ 10 ’8 ’’ ’ ’9’ 15 10 ’ ’1’ ’ 15 Paragon Group USA Customer Service:(877) 782 4482 Email:cs-outdoors@paragongroupusa.
Introduction Thank you for purchasing the Gazebo GZ3XL. When properly assembled and maintained, this gazebo will provide many years of enjoyment! These instructions include helpful hints and important information needed to safely assemble and properly maintain the gazebo. Please read these instructions completely before you begin. Our patented gazebo has been designed for easy assembly. All steps can be completed by a team of four people. The assembly should take about two hours.
of 24
five contact customer service before beginning assembly: Customer Service:(877) 782 4482 Email:cs-outdoors@paragongroupusa.
8 5 60 7 4 5 16 7 12 5 36 32 3 37 12 8 38 4 8 39 16 4 40 16 4 41 1 42 1 43 4 5 4 5 4 5 31 19 2 7 M6*33mm Aluminium Composite Roof Panel 32 2 20 33 7 Aluminium Composite Roof Panel 34 1 21 5 M6*38mm M6*45mm Φ4*8mm 35 M6 Roof Top Cover 22 1 5 2 5 Roof Top Connector Beam 23 U-shaped Connector 2 24 6 1052mm 25 2 6 2 6 886mm 26 886mm 27 2 T - connector 6 44 790mm X - connector 20 28 2,5 45 Top center connector M6*8mm 29 148 2,3
STEP 1 Assembling the Corner Profiles Place all the parts on a level surface. Make sure the pieces are in the correct positions before assembling. Carefully follow the order of assembly to ensure an easy installation. Wear proper safety gear including work shoes, gloves and goggles.
1.B Slide support frames (2) over lower end of corner profiles (1). Attach support plates (3) to corner profiles as shown, using four tapping screws (30) for each plate, make sure all tappnig screws are perpendicularly into the proflie holes.
12 28 16 28 28 28 28 8 of 24 29 56
Attach eight outer roof connectors(10) and four inner roof connectors(9) to each long rail set at pre-drilled screw holes, using screws(29). 29 Attach three outer roof connectors(10) and two inner roof connectors(9) to each short rail set at pre-drilled screw holes, using screws(29).
29 42 29 32 29 29 29 36 36 36 10 of 24 32 36 42
42 29 36 29 36 11 of 24
STEP 4 Securing the Gazebo to the Ground 4.A Fasten the gazebo frame to the ground, using four spikes (39) for each support plate. Lower support frames (2) to cover support plates (3). Components 1 2 Ground spike (39) 1 x 16 39 3 3 Optional Securing the Gazebo to a Concrete Floor or Wood Deck Concrete Floor: Components 1. Using a concrete drill, drill holes into the concrete floor, corresponding to the holes in support plates (3). 2.
Roof Gable Profile(11) 2346mm Roof Gable Profile(12) 1696mm Roof Gable Profile(13) 1164mm Roof Gable Profile(14) 1164mm x 4 x 4 x 4 x 4 Screw(47) x 4 T-connector A(43) x 4 Roof Top Top center Connector Beam(22) connector(45) Roof Top Cover(21) x 1 Screw(28) x 1 Screw(29) x 4 x 44 x 4 Screw(31) U-shaped X-connector (44) Connector(23) x 2 Screw(33) x 8 x 4 x 4 Nut M6(35) x 12 11 , 12 , 13 , 14 3. 1.
31 35 29 35 31 29 Install roof gable profiles (12). Using screws (47) nuts (35) connect top center connector (45) to top connector beam(22). Using screws (29)connect profiles (12) to inner roof connector (9) on long roof profiles sets (5,6) and the other end to roof top center connector(45).
28 28 28 28 33 33 33 Attach T-connectors (43) to underside of roof gable profiles (12) , using screws (29) as shown. Attach X-connectors (44) to underside of roof gable profiles (11) , using screws (29) as shown. Connect profile (13,14) to X-connector (44) and the other end to T-connector(9) using screws(29).
Corner cap(46) Roof Profile(27) 29 x 4 x2 16 8 30 Attach roof goble profiles (24,25,26,27) to T-connectors(43) and X-connector (44). 11 25/24 11 24/26 44 11 29 14 12 12 13 43 12 11 13 14 12 1 29 25 26 13 29 14 27 24 26/27 24 27 25 11 27/25 13 26 14 12 11 BELOW 1 30 46 11 Fasten corner cap(46) to the top of corner profile(1) from inside, using screws(30) as shown.
Gently cut on the edge of the panels on both side with knife and remove protective plastic of roof panels. Place with black surface toward the sun facing out when installing.
) 20 34 to 15 20 12 13 12 13 15 34 11 14 13 12 12 11 12 14 13 13 14 20 12 20 12 34 11 18 of 24 14 13 11
Roof Gable Profile Roof Gable Profile Roof Gable Profile Roof Gable Profile (11A) (12A) (13A) (14A) x 4 x 4 12 x 60 x 4 x 4 12 12A Screw(32) 32 27 25 12 20 15 12 32 34 12A 20 12 12 19 of 24
12 14 26 16 11 24 16 12 14 14 13 12A 12 , and fasten with two screws(32) from below(inside gazebo).
Fit roof panel(17,18,19) on top of roof profiles(11,13,14) as shown and fasten with one screw (34) to outer roof connector(10). Place roof profiles(11A) on top on roof profiles(11) and fasten with screws(32) from below.
Continue in a clock-wise direction as shown. 11A 13A 17 12A 15 14A 12A 16 20 11A 18 17 18 14A 13A 19 19 17 18 13A 14A 18 11A 16 14A 15 20 12A 12A Place the roof panel (17,18) on top of profiles (11,13,14) , fasten with screw (34) from below. Place the roof gable profile 11A on top of 11 , fasten with screw(32) from below of 11.
Place the roof gable profile (13A) on top of (13) , fasten with screw (32) from below of 13.
Gazebo GZ3XL Aluminium Composite Roof Panels Assembly Instructions WARRANTY: Warranty covers damage due to manufacturing defects only. Warranty does not cover weather inflicted damage (Force Majeure) and/or damages caused by not following assembly instructions and adhering to warnings in manual. ATTENTION: Roof profiles,roof planels and gables must be aligned properly during assembly to minimize any possibility of leaking.
