11 Personal

 Define whether the partition will be Primary, Extended or Logical. You can choose the desired partition type

from the pull-down list. As a matter of fact, the available alternatives fundamentally depend on the selected

block of free space - within the Logical free space, only Logical partitions can be created; Within the Primary free

space, both Primary partitions or the Extended Partition can be created.

 Partition Size. Define the size (in Mb) of the new partition.

 Free space before. Define the position (in Mb) of the new partition relative to the beginning of the block of free

space.

 Free space after. Define the amount of trailing free space (in Mb) at the end of the new partition.



Partition size and position may also be defined by using the drag-and-drop technique. To do

that, just carry out the required operation on the Disk Map. The virtual operations are to be

available.

 File system for new partition. From the pull-down list select a file system the newly created partition will be

formatted to, otherwise the partition will remain unformatted (so that it will not be ready to use).

 Volume label. Enter a label for the selected partition in this textual field. It is an irrelevant parameter usually

used for drive identification.

 Drive letter assignment. The pull-down list contains vacant drive letters that can be associated with the newly

formatted partition.

In addition, there is the possibility to make further detailed settings (although the default values will do in most cases).

To activate the advance mode, you need to click the More options button at the foot of the dialog page. Depending on

the chosen file system, the following options become available: