User Manual

33 34
FCC
a. This device complies with Part 15 of FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
b. Warning: Changes or modifications to this unit not express-
ly approved by the part responsible for compliance could void
the user’s authority to operate the equipment.
c. NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a resi-
dential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for
help.
d. This device is also designed to meet the requirements for
exposure to radio waves established by the Federal Communi-
cations Commission (USA). The SAR limit adopted by the USA
is 1.6 W/kg averaged over one gram of tissue. The highest SAR
value reported to the FCC for this device type complies with
this limit.
IC
a. This device complies with CAN ICES-3 (B)/NMB-3(B).
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interfer-
ence that may cause undesired operation of the device.
b. Cet appareil est conforme à la norme CAN ICES-3 (B)/NMB-
3 (B).
Le présent appareil est conforme aux CNR d'Industrie Cana-
da applicables aux appareils radio exempts de licence. Son
fonctionnement est soumis aux conditions suivantes : (1)
l'appareil ne doit pas causer d'interférence et (2) l'appareil
doit accepter toute interférence, y compris une interférence
pouvant entraîner un fonctionnement non désiré.
The frequency band(s) in which the radio equipment operates;
maximum radio-frequency power transmitted in the frequency
band(s) in which the radio equipment operates.
2.4 GHz Wi-Fi
2402-2480 MHz for BT
Maximum radio power: <20 dBm for 2.4 GHz Wi-Fi, <10 dBm
for BT