Installation Manual

5300 Series

DC Wiring

1. Converter DC output leads. See Note 2.

2. Lugs (3) for positive DC input of 12 volt

supply from the converter or batteries.

3. 12 volt negative terminal bar. Use for

negative connection of the converter, 12

volt loads, and the battery system.

4. Converter DC negative output leads. See

Note 2.

5. Converter output protection fuses. Use

same type and rating. Do not over-fuse!

6. 12 Volt branch load circuit positive

connection terminals. Fuse each load

circuit per current NEC Code (Table 310-

16) appropriate to the AWG conductor

size and temperature rating of the

conductor used. See Note 1.

7. Refer to AC wiring label on page 5

for terminal bar torque ratings and

the DC Distribution panel for wiring

lug torque ratings. Tighten all wiring

connections to the specified torque

values.

Notes:

1. DC load circuit fuses not supplied.

2. Converter may have 1 or 2 DC positive and negative output leads depending

on the DC output amperage capacity.

Electrical installation shall comply with the standards

and safety requirements of the ANSI/RVIA 12V

Standard for Low Voltage Systems in Conversion and

Recreational Vehicles, NFPA 70 National Electrical

Code and the NFPA 1192 Standard for Recreational

Vehicles.