PING))) documentation v1.5

Test Data

The test data on the following pages is based on the PING))) sensor, tested in the Parallax lab, while

connected to a BASIC Stamp microcontroller module. The test surface was a linoleum floor, so the

sensor was elevated to minimize floor reflections in the data. All tests were conducted at room

temperature, indoors, in a protected environment. The target was always centered at the same elevation

as the PING))) sensor.

Test 1

Sensor Elevation: 40 in. (101.6 cm)

Target: 3.5 in. (8.9 cm) diameter cylinder, 4 ft. (121.9 cm) tall – vertical orientation