BASIC stamp manual v2.2

Using the BASIC Stamp Editor

Page 64 • BASIC Stamp Syntax and Reference Manual 2.2 • www.parallax.com

Figure 3.24: The Debug

Appearance Tab under

Edit  Preferences.

The “Wrap Text to” field gives two options, Pane and Page. Wrapping to

Pane is the default, and causes text to wrap at the right edge of the

Receiver pane, reflecting the current visible size that the user happens to

have set for the Debug Terminal’s window. Wrapping to Page, however,

causes text to wrap at a specific line width, regardless of the user’s current

Debug Terminal window size. The “Page width (characters)” field is

enabled when wrap mode is set to Page. The default page width is 32,

characters and the range is 32 to 128. Note: wrapping to page can be

handy to maintain formatting of formatted tabular information, but could

lead to information being displayed off the edge of the Receive pane if the

Debug Terminal is sized too small.

The maximum Receive pane buffer size is defined in terms of lines. It can

be set to any power of two between 256 and 8192; 1024 is the default. Data

received by the Debug Terminal is maintained in this buffer for display on

TEXT WRAPPING IN THE DEBUG

ERMINA

AXIMUM BUFFER SIZE.