Robotics with the Boe-Bot text v2.2

Page 96 · Robotics with the Boe-Bot
Figure 3-5
Battery Pack
Mounting
Hardware
For use with the Board of Education For use with the HomeWork Board
Instructions:
√ Use the flathead screws and nuts to attach the battery pack to underside of the
Boe-Bot chassis as shown on the left side of Figure 3-6.
√ Make sure to insert the screws through the battery pack, then tighten down the
nuts on the topside of the chassis.
√ As shown on the right side of Figure 3-6, pull the battery pack’s power cord
through the hole with the rubber grommet in the center of the chassis.
√ Pull the servo lines through the same hole.
√ Arrange the servo lines and supply cable as shown.