Owner's Manual

Parasound
®
200 Integrated Owner’s Manual
Page 14
Turn On Volume & Favorite Volume
Turn On Volume
You may wish your 200 Integrated to come on to the same volume setting every time it is turned on. This
can be particularly useful if you sometimes listen at high volume levels and you want to avoid a blast of
sound the next time you turn it on. Or you may have a preferred listening level. To program the Turn On
Volume setting follow these steps:
Setting the Turn On Volume:
1) Adjust the volume to the level you wish to program
2) Press the “Set” button
3) Press the remote control’s power “On” button
Now every time the 200 Integrated is turned on the volume will automatically be set to
the level you have programmed.
Cancel the Turn On Volume Feature (Use Last Volume)
You may wish to cancel the “Turn On Volume” feature. In this case, when the 200 Integrated turns on the
volume will be at the same level as when it was turned off. Follow these steps to have the 200 Integrated
turn on to the level it was last used at:
Cancel the Turn On Volume Feature:
1) Press the “Set” button
2) Press the remote control’s power “Off” button
Now when the 200 Integrated turns on the volume will be set to where it was last used.
Memorizing a Favorite Volume Level (Vol Mem Button)
For your convenience, you can also memorize your favorite listening level. Once memorized you can easily
jump to this listening level by pressing the “Vol Mem” button on the remote control.
Memorizing a Favorite Volume Level:
1) Adjust the volume to the level you wish to be memorized
2) Press the “Set” button
3) Press the “Vol Mem” button
You can now jump to your favorite listening level by pressing the Vol Mem button at any time. This is
different than the “Turn On Volume” you may have already set.
Factory Reset
Performing a factory reset will erase all user settings. This includes input names, turn on volume memory,
favorite volume memory, input level offsets, tone control settings and balance setting.
Factory Reset Procedure:
1) Unplug the AC power cord
2) Press and hold the front panel Power button
3) Plug back in the AC power cord [display will indicate user memory has been reset]
4) Release the front panel Power button