O W N E R ' S M A N U A L PAL-80, PAL-65, PAL-45 Precision Architectural Loudspeakers w w w.pa ra sound.
Introduction Congratulations on your purchase of this Precision Architectural Loudspeaker system and thank you for choosing Parasound. The PAL-80, PAL-65, and PAL-45 Precision Architectural Loudspeakers were developed using the finest driver and crossover components available. Countless hours of computer modeling were spent to insure accurate audio reproduction in a variety of installations where placement compromises are sometimes unavoidable.
Observing Correct Speaker Wire Polarity When you connect speakers to your amplifier, you will notice that one side of the two conductor speaker wire will have some sort of mark: either printing, a raised ridge on the insulation, or a different color of conductor to let you know which wire to connect to the positive and which to the negative speaker terminals so you can repeat the connection on the power amplifier's binding posts.
Three Position Treble Adjustment The High adjustment slide switch on the front of the speaker allows you to adjust the tweeter level - 3 dB or +3 dB from its 0 dB middle position. If you are mounting the speaker in a “live” room with many reflective surfaces, you may want to attenuate its treble response. Conversely, if you are mounting the speaker in a “dead” room with many absorbent surfaces, you may want to boost its treble response. Installing Precision Architectural Loudspeakers 1.
Dual Dome Tweeters Swing arm in locked and mounted position Kevlar Woofer with Dual Voice Coils H ig h Three Position Treble Adjustment Switch Swing arms in retracted position PAL-80, PAL-65, and PAL-45 Bezel Assembly Speaker Input Assignment Switch Paralleled Input Left Stereo 8 Ω Input or Paralleled 4 Ω Input PA L-8 0 P recisi o Independent Inputs udsp n Architectural Lo eak er Right Stereo 8 Ω Input PAL-80, PAL-65, and PAL-45 Crossover PCB 5
PAL-80 Precision Architectural Loudspeaker Specifications Frequency Response Nominal Impedance Minimum Impedance Sensitivity 1 Watt/1Meter RMS Power Range Woofer Size Cone Material Surround Material Tweeter Size Tweeter Diaphragm Material Crossover Slope 48 Hz-22 kHz +/- 2 dB 8 Ohms 6 Ohms 89 dB 10-100 Watts 8" Kevlar Polyurethane Dual 3/4" Dome Aluminum 12 dB per octave Dimensions Hole Cut-Out Outer Edge of Frame 9 3/8" 10 3/4" PAL-65 Precision Architectural Loudspeaker Specifications Frequency Respons
Parasound Products, Inc. 950 Battery Street, San Francisco, CA 94111 415-397-7100 / FAX 415-397-0144 www.parasound.com Features and specifications subject to change without notice © 2000 Parasound Products, Inc. Rev 0.
