User's Manual

Sistema FIREMASTER III "Millennium" Manuale di istruzioni

2 . "TESTING" ICON

This mask allows to select the functions for SET, MODIFY and CHECK all

parameters of the Remote Units active at the same moment.

Using keys F1 and F2, one can select one of the two possible operating modes:

"TEST LINE" and "TEST UNIT". With "SEL" F6 it will be open the mask

relative to the selected icon.

2.1 "TEST LINE" ICON

This icon selects the menu of SINGLE LINE TEST. This operating mode is the

same used in the previous version FIREMASTER II: it is possible to "call" one line

at the time and the following parameters will be returned: the number of the

Remote Unit containing this line, the sequence of that line, the ohmic resistance of

the line, the batteries voltages, the level of the radio signals both received and

transmitted and, if the sequence is of "timed" type, also the time value. The

sequence and time parameters can be modified at any time and the variations will

take place immediately being stored in the memory of the remote unit.

NOTE: any modification made with this function, WILL BE NOT COPYED in

the memory of the Base Unit and thus the "SHOW" data eventually downloaded

from a PC with the serial line, will REMAIN UNCHANGED. The user must have

well clear in mind as, if the show has been created on a PC using a commercial

program of show management and then loaded in memory, it will be mandatory to

verify, test and modify it using exclusively the functions of "SHOW EDITING",

"SHOW VERIFY", "IMPORT/EXPORT" and "UNITS PROGRAM" providing

a constant parallelism between the data stored in the Remote Units and the