User's Manual

Sistema FIREMASTER III "Millennium" Manuale di istruzioni
23
Proceed now INCREASING the LINE value with F11 and press the "AUTO
INCREMENT" key on the main keyboard: the time value will be automatically
incremented by the selected quantity and the sequence, if not otherwise set, will be
automatically timed. Continue the same way till the sequence end.
REMOVE THE TIMING FROM A SEQUENCE ALREADY TIMED.
Select the line with the sequence to modify, press now F4 to select "TIME": the
timing option will be CANCELLED simply using the Ð key. If the timing should
be RESTORED, press the Ï key.
WARNING: in order to cancel the timing of a line, IT IS NOT SUFFICIENT to
set at ZERO the time value! You must use the above procedure instead.
HOW TO REMOVE ALL TIMED SEQUENCES FROM THE SAME
REMOTE UNIT.
When a new show is to be created and all Remote Units are to be completely re-
programmed, it could be advisable to define first as NOT TIMED all the lines of
the Units to be used in that show and then proceed to a new programming as
required. It could result UNSAFE (when this should not generate more serious
problems during the show execution), to leave defined as timed one or more lines
EVEN IF NOT USED.
The FIREMASTER SYSTEM (just as its previous version) has a practical function
used to do that. It can be activated with F9 key and the following mask will appear: