User's Manual

Sistema FIREMASTER III "Millennium" Manuale di istruzioni
27
From inside the mask "TEST MENU" select the "TEST UNIT" icon: the mask
"TESTING UNIT #…" will appear
Because a specific Remote Unit has been not selected nor checked yet, by default, it
will be shown the 12 first lines situation of Remote Unit #1. All parameters are still
unassigned or set to ZERO.
Press the key F9 "UNIT" to select, among the ACTIVE Remote Units, the one to
be checked. It will be shown a window to type in the Unit number (1 to 255).
Press "ENTER" to confirm the data: the Base Unit TX2000 will start immediately
to send a data request for the selected Remote Unit. A time interval of about 4
seconds is necessary to check the Unit and obtain the answer with all data. During
this time, the following message will be displayed.