User's Manual
Table Of Contents
- SYSTEM FIREMASTER IV
- "Millennium Three"
- CONTENTS
- 1. Base Station - Control Unit TX5000 3
- 3.3.5 " AUTOMATIC SHOW ” Mode 55
- 3.3.6 Options in “SHOW” mode 58
- 3.3.7 Operation Notes when in "FIRE MODE" 59
- 4.8.2 Coaxial cable connection 74
- 4.8.3 RS-485 77
- 4.8.4 RS-232 79
- 5. BPK48-A Battery Pack 81
- _
- _
- 1. COMMAND UNIT MODEL TX 5000
- BASE STATION MODEL TX5000
- 1.1 FRONT-PANEL DIAGRAM
- _
- _
- 1.1.1 Front-panel commands description
- 1.2.1 Instrument case and connector description
- 1.3 Operation
- 1.5. "SHOW MANAGEMENT" Mask description
- 1.6. "TOOLS" Mask
- 1.7. "SYSTEM SETUP" Icon
- 1.8. "OLD UNITS SETUP" Icon
- 1.9. "TONE GENERATOR" Icon
- 1.10. TONE GENERATOR TESTING
- _
- 1.11. "SMPTE TEST" Icon
- 1.12. "MIDI TEST" Icon
FIREMASTER IV "
MillenniumThree
" radio shooting system User’s manual
able to automatically recognize these units when the TEST or
PROGRAMMING signals are issued. PRACTICALLY: the User
will define once for all the "old generation" type Units and will
type the corresponding numbers in the cells of this mask.
4- TX5000 Base Unit and any combination of Remote Units
(RX24, RX24-B and RX48). As in the previous case it will be
necessary to specify the numbers for the RX24 units (Firemaster
II) eventually present. RX24-B (Firemaster III) units are
completely compatible with the new TX5000 Base unit and don’t
require any setup in this mask.
The numbers of the "old generation" type Units, can be inserted IN
ANY ORDER and IN ANY CELL among the 140 available. For an
obvious readability reason, it is suggested to proceed orderly starting
from the uppermost cell on the left. One should insert ONLY the
numbers of the FIREMASTER II "old generation" Remote Units
(RX24), leaving at ZERO all other cell values.
Just suppose an user already owing 8 "old generation" Units
numbered 1 to 8 and purchasing 10 more Units of "new generation"
(FIREMASTER III or FIREMASTER IV) numbered 9 to 18, plus
one Base Unit TX5000. In order to operate indifferently with all
Units and to completely take advantage from the resources of the
new system, he should set the "SETUP OLD UNITS" mask as
follows:
13