User's Guide

Desktop Installation
8 The following installation instructions configure the equipment for desktop operation using a
free-standing accessory kit (PAE part no. 70-3060TR1). With reference to Fig. 6 locate and identify the
components of the free-standing kit.
(a) At the front of the equipment locate and remove the four securing screws from the left and
right rack mounting brackets. Separate the handles from the brackets by removing the two
securing screws. Retain the handles.
(b) Attach the handles, removed in (a), to the left handle plate (item 3) and the right handle plate
(item 2) using the four (two per handle) M5 x 16 mm cap head screws (item 10). Secure the
handle plates to the unit using the eight (four per plate) M4 x 16 mm pan head screws (item 9)
and M4 crinkle washers (item 14).
(c) At the rear of the equipment locate and remove the ten rear panel assembly retaining screws
(item A) and carefully lower the rear panel assembly.
(d) On the left and right-hand side of the PSU compartment locate the four symmetrically placed
holes, note that the two rearmost holes are countersunk. Fit the eight hexagonal M3 x 12 mm
spacers (item 4) to the sides using the four M3x6mmpanhead screws (item 11), four
M3x6mmcountersunk screws (item 8) and eight M4 crinkle washers (item 14).
(e) Raise and secure the rear panel with the ten retaining screws (item A) removed in (c).
(f) Fit the two side covers (item 7) to the hexagonal spacers using the M3x6mmcountersunk
screws (item 8).
(g) Fit the top cover support bracket (item 5) to the rear panel above the filter using the two
M4x6mmpanhead screws (item 12) and crinkle washers (item 14).
(h) Fit the top cover (item 6) using the M3x6mmcountersunk screws (item 8).
(i) On the underside of the equipment locate the four front and rear M4 countersunk crosshead
screws that secure the base plate. Remove the two outer screws from both the front and rear
locations and fit the feet (item 15).
Section 3 3000DV2 Radios
Page 6