User's Guide

VIEW RADIO ID
60 The previous sequence can be used to both set, and view, the current ID of a radio. If a number
does not prefix the key sequence then the ID is displayed for 5 seconds, but can be cancelled before the
5 seconds have elapsed by pressing the CE key.
Example. Viewing the Radio’s ID
61 To view the current ID, enter the following key sequence:
SHIFT s,8
62 The radio’s front panel displays show the ID as shown below.
SET EQUIPMENT BAUD RATE
63 If the radio is to be remotely controlled at a baud rate other than the default 1200 rate, a key
sequence can be entered to select the required baud rate. Valid baud rates are: 1200, 2400, 4800 and
9600.
Key sequence: baud rate, SHIFT s,9
64 Error 38 (Err 38) is displayed if an invalid baud rate is selected.
Example. Setting the Baud Rate
65 To set the baud rate to 9600, enter the following key sequence:
9600, SHIFT s,9
VIEW EQUIPMENT BAUD RATE
66 The previous sequence is used to set, and view, the baud rate of the radio being remotely
controlled. If a number does not prefix the key sequence, the current baud rate setting is displayed for 5
seconds, but can be cancelled before the 5 seconds have elapsed by pressing the CE key.
Example. Viewing the Current Baud Rate
67 To view the current ID, enter the following key sequence:
SHIFT s,9
The radio’s front panel displays show the baud rate as illustrated below.
Section 3 3000DV2 Radios
Page 24
002
Id
FREQUENCY
CHANNEL
MONITOR
9600
--
bAUd
FREQUENCY
CHANNEL
MONITOR