User's Guide

Table 4-5 Error Message Codes
Code Meaning Action
01
* Check sum error
Indicates marginal line conditions. Clears on next
correct polling sequence or pressing CE key.
02
Not used
03
Not 25 or 8.33 kHz channel
Press the CE key and enter the correct frequency
related to relevant kHz channel spacing.
04
* Attempted to change
frequency at RCU with
LOCK selected
Indicates that the LOCK function is selected.
Press the CE key to regain Edit Mode. Select the
UNLOCK function at the RCU unit to allow the
locked out function to be set - if permitted.
05-09
Not used
10-14
Not used
15
FM mode not available at this
frequency
Press CE key, select another frequency if FM
required.
16
* Serial Data Failure
This error code is displayed only at the 3000V2
Remote Control Unit (RCU). This code indicates a
communication link failure between the
transmitter or receiver and the 3000V2 RCU. The
fault can be in the transmitter or receiver, data link,
or the 3300 Data Unit. The error code clears when
the CE key is pressed, but is displayed again after
approximately ten seconds if the fault has not been
cleared.
17-24
Not used
25
Attempt to change frequency
of maritime channel
Exit maritime mode if change required
26-36
Not used
37
RF filter incompatible with
transmission mode
Remove RF filter or select single frequency
transmission
38
Out of range Press CE key and re-enter data
39
* Same IDs
One or more radios in the system have the same
IDs. Reconfigure radio IDs and restart.
Applicable to split and non-split sites.
Section 4 3000DV2 Radios
Page 34