User's Guide

Table 4-5 Error Message Codes (continued)
Code Meaning Action
40
* Too many radios in system
Split-site operation - two radios only.
Non split-site operation - 15 radios.
41
* Transceiver split. One or
more radios in split-site
configuration is a transceiver
Reconfigure radios and restart.
42
* Two transmitter split. Both
radios in split-site are
transmitters
Reconfigure radios and restart system.
43
* Two receiver split. Both
radios in split-site are
receivers
Reconfigure radios and restart system.
44
* VHF/UHF split. Radios in
split-site have different
frequency bands
Reconfigure radios and restart system.
45
* In split-site operation a radio
has not responded to the
3000V2 RCU
Reconfigure radio and restart system.
46
* Radio Busy
Radio is unable to perform required function. For
example radio commanded to exit Anti-Jam when
not in Anti-Jam mode. Press CE key to
acknowledge fault and continue operation.
47
* Havequick function not
available
Havequick function not available at this radio.
Press CE key and select another operation.
48
WB mode not available at this
frequency
Press CE key, select another frequency if WB
required.
49
Link 11 mode not available at
this frequency
Press CE key, select another frequency if Link 11
required.
50
Crypto mode not available at
this frequency
Press CE key, select another frequency if crypto
mode required.
Note...
* means error message code only displayed at an associated remote control/monitoring equipment
(such as a PAE 3000V2 remote control unit).
3000DV2 Radios Section 4
Page 35