User's Manual

T6T VHF 100 W Transmitter Page 12 Installation
Back to Transmitter
Main Page
Rear Panel Connectors
The rear panel connectors are shown in Fig 8 and listed in Table 4. Select which connectors are going
to be used and then make connections as required.
Fig 8 Rear Panel (Connectors)
Table 4 Rear Panel Connector Usage
Connector Type Usage
AC supply 2 x IEC Terminating the ac input supply.
DC supply 2 x XLR 3-pin Terminating the dc input supply.
Antenna N-type Terminating the antenna feeder coaxial cable.
External speaker 3.5 mm stereo jack Connects an external loudspeaker for monitoring sidetone.
MARC 9-way D-type Used to connect to a MARC remote site equipment.
Used to connect a T6 controller or hub.
Used to terminate remote audio and PTT signals when a
remote site equipment or T6 controller is not used.
MARC audio RJ48 Used as an alternative to the MARC connector for terminating
remote audio and PTT signals.
MARC data RJ48 Used as an alternative to the MARC connector for terminating
data signals to and from a compatible data system.
Facilities 15-way D-type Provides a number of optional facilities that can be used as
required.
T1/E1 RJ48 Used for connecting the radio to a Mode 3 network computer,
connecting a transmitter and receiver together as a Mode 2
base station, or for connecting to a digital voice and data
network.
HLDC RJ48 Used to connect to a Mode 2 network computer.
RF VOLTAGES
DANGER HIGH
ANTENN A
CONNECT
ANTEN NA
BEFORE
USE
F15A 32V
110-240V T4A 250V IEC
110-120V T4A 125V UL
FUSE F1 / F2
FUSE F3 / F4
SEE INSTALLATION INSTRUCT IONS BEFORE
DISCONNECT SUP PLIES WHEN NOT IN USE
DC SUPPLY
CONNECT ING SUPPLIES
21.6-32V 28 A
RATINGS
POWER 800VA max
AC SUPPLY
48-62Hz
FUSE F2
FUSE F1
+
-
+
-
DC SUPPLIES
~ AC SUPPLIES
FUSE F4FUSE F3
FACILITIES
SUPPLY
MARC
AUDIO
T1 / E1 HDLC
DATA
MARC
MARC
DANGER HIGH
RF VOLTAGES
USE
BEFORE
CONNECT
USE
DANGER HIGH
RF VOLTAGES
CONNECT
BEFORE