User's Guide

Page 24
Back to Transceiver
Main Page
Switching On
When the POWER SWITCH is set to the Standby position, dangerous voltages are still present in
the transceiver's internal power supply circuitry. To ensure safe working, the transceiver must be
isolated from the ac and dc input supplies.
When installation is complete, the transceiver should be switched on at the rear panel 2-way rocker
Power switch. The Power switch is used to switch on, and switch off, power to the transceiver's circuitry
but does not remove power from the radio.
Under normal circumstances this screen is displayed when the radio is switched on.
The bottom row begins empty and dots are added as the initialisation progresses. When the initialisation
is complete the Main Screen is displayed.
Note ...
All radios have a standby function to extend power supply life when the radios are not required to be
operational. With the standby function enabled the transceiver is unable to transmit or receive and
the display is blank. Remote control serial ports and the front panel control knob remain active to
allow normal operation to be restored.
T 6 D i g i t a l R a d i o
( c ) 2 0 0 3 P a r k A i r
I n i t i a l i s i n g . . . .
. . . . . . . . . . . . . . .
WARNING
Dangerous Voltages
= Standby= On