User's Manual

WIFI kit - Neops base terminals - Operation manual
7
2.3 Description of functions
2.3.1 Installation and initialisation
The slave board and modem are mounted on the main board.
Make sure the antenna is properly.
Function 80: modem initialisation.
To initialise the modem, use on-site programming function 80 described below:
1.
MODEM PRESENT
YES: 1 NO: 2
Enter 1 to start initialising the modem.
Modem initialisation:
From that point on, the main board initialises the modem without any more user
input. The main board displays progress of the initialisation stage:
2.
PLEASE
WAIT
During this stage, the main board powers up the modem.
3.
MODEM
INITIALISATION
During this stage, the modem sends initialisation.
If the initialisation procedure fails at this point (message “Init. not completed”),
that means the slave board is not answering the main board.
If the procedure is completed correctly, the main board moves on to the next
stage.