User's Manual

WIFI kit - Neops base terminals - Operation manual

NETWORK

REGISTRATION

During this stage, the main board waits for the modem to register on the Wifi

network.

1. If initialisation fails during this stage (message “Init. not completed”), that

means that the modem cannot be registered on the Wifi network : check

that the antenna is correctly connected to the modem and that the

antenna cable is correctly screwed to the antenna adapter.

INITIALISATION

COMPLETED

When the main board displays this message, that means that the modem has been

successfully initialised. Initialisation is used to:

• check assembly in the terminal;

• check that the modem is capable of registering with the network.

That is why function 80 should be repeated every time, whenever:

• a new kit is installed;

• the kit is removed from then put back into the terminal;

Once the modem has been initialised, it still needs initialising on the terminal:

• call numbers: server-side IP address (function 44);

• configuring whether or not alarms are sent to the server (function 42).