User's Manual

WIFI kit - Neops base terminals - Operation manual
9
Programming Parkfolio
Neo
On-Line numbers (function 44)
This function is used to save the Parkfolio
Neo
On-Line numbers in the memory of
the main board.
Numbers 1 to 10 are the server's IP address for Wifi.
2.3.2 Wifi communication
To make a Wifi call, just use function 44 to programme the IP address of the
Parkfolio
Neo
On-Line.
In order to make a GPRS call, the terminal needs to know the server’s UDP Port
number : this is the number of the port used to communicate with Parkfolio
Neo
On-
Line. The port number entered while setting up Parkfolio
Neo
On-Line for Wifi
communication is to be used here.
Function 40: communication test
Function 40 is used to test communication between the terminal and the
communication server irrespective of the communication medium (Mobitex, GSM,
SMS, GPRS and Wifi).
1. If a GSM Data number is programmed, the main board will try and make a
GSM Data call with Parkfolio
Neo
On-Line. If the call succeeds and
communication with Parkfolio
Neo
On-Line is satisfactory, the main board
displays the message "Communication test OK".
2. If the programmed number is the IP address, the terminal tries to
communicate via Wifi with Parkfolio
Neo
On-Line:
o If the communication is satisfactory, the main board displays
"Communication OK";
• If the main board displays “Transmission problem”, there may be several
reasons for such behaviour:
1. The IP address of the server is incorrect;
2. Parkfolio
Neo
On-Line is not receiving data from the terminal (incorrect
firewall setup, incorrect router setup etc.);
3. Parkfolio
Neo
On-Line is not responding (the Parkfolio
Neo
On-Line service
is down).