User Manual

9. CHECKING LID SHUT-OFF DEVICE

1. Lift the lid.

2. Turn one hotplate burner tap to its full on position and push the ignition button.

3. Close lid. There should now be no gas supply to the hotplate and the burner will go out.

4. Turn off the hotplate tap and lift the lid. The gas supply should now be restored to the hotplate. When

the tap is turned on.

10. CHECKING THE OVEN

1. Turn the oven thermostat to Mk.9 and check that there is sparking from the ignition system. This should

continue until the oven burner is alight.

2.. When the oven burner lights up the sparking should cease, there should be a low gas rate at first to the

oven burner which is the flame supervision device (F.S.D.) by pass rate.

3. When the F.S.D. phial has heated up it opens the F.S.D. valve and the main gas stream flows to the

burner.

4. After 1 minute check that the flames covers the full width of the burner and is stable.

5. Set the oven thermostat to Mk.2, close the oven door and check that after about 10 minutes the flame

has reduced in size.

6. Turn off the thermostat and check that the oven flames go out.

GENERAL NOTE

Instruct the user on how to use the appliance and its ignition system. Refer the user to the wording in the

inside cover which gives advice on the safe operation of the appliance.

CSIG500X 311522302