Operation Manual

22
PDSP 1000 B2
GB
Troubleshooting
Fault/possible cause Remedy
No material fl ow
The air is not dry
enough.
Install a water separator
in your compressed air
system.
Air pressure too low
Increase the output
pressure of your com-
pressor.
Attachment not sitting
correctly
Ensure that the attach-
ment is fi rmly on the
appliance and that
no air escapes at the
sides.
Blocked sand-blasting
material pipes
Check that no lumps of
sandblasting material
are blocking the pipes.
Preferably use a
blow-off gun to clean
blocked pipes.
(Wear protective
glasses!) Also check
the outlet opening of
the tank.
Sand-blasting pattern not as expected
The air is not dry
enough.
Install a water separ-
ator in your com-
pressed air system.
Grain size of the sand-
blasting material not
uniform
Replace sand-blasting
material.
Sand-blasting material
impure
Clean/replace sand-
blasting material
The attachment is worn
out
Replace the attach-
ment
Other defects
Please contact an expert or your retailer.
Components
(see back fold-out page)
Item no. Description Amount
01 Housing 1
02 Screw 2
03 Screw 1
04 O-ring 1
05 Pin 1
06 Air valve spring 1
07 O-ring 1
08 Screw nut 1
09 Spring 1
10 Trigger 1
11 Air inlet 1
12 Socket 1
13 Nozzle 1
14 O-ring 2
15 Beaker ring 1
16 Connecting piece 1
17 Nozzle 1
18 Control lever 1
19 O-ring 1
20 Connection lever 1
21 Pin 1
22 Adjusting knob 1
23 Screw 1
24 Container 1
25 Screw nut 1
26 O-ring 1
27 Protective cover 1
28 Screw 1
29 Screw cap 1
30 Handle cover 1
31 Nozzle 1
32 Nozzle 1
IB_43089_PDSP1000B2_LB1.indb 22IB_43089_PDSP1000B2_LB1.indb 22 28.05.14 08:5928.05.14 08:59