User Manual

Tip: Turn the clevis clockwise or counterclockwise on the linkage.

• Pull the tube from the clevis to the linkage.

• Carefully spread the clevis and put the clevis pin into the desired hole

in the control horn.

• Move the tube to tighten the clevis onto the control horn.

After binding a transmitter to the model receiver, set all trims and sub-trims

to 0, then adjust the clevises by hand to center the control surfaces.

Fly the model at factory settings before making

any changes. For pilots who wish for more control

throw, adjust the position of the control linkages on

the servo arms and control horns for

increased travel.

102mm

(4 inches) from the leading edge

of the wing at the fuselage.

Place the battery all the way forward in the battery

compartment and hold the battery in place using

hook and loop straps. It is easiest to balance the

aircraft with the aircraft inverted.

Center of Gravity (CG)

Factory Settings

Installing Clevises on Control Horns and Control Centering

Ailerons

Arms

Rudder

Horns

Flaps Nose Gear Elevator

Servo Strut