Instruction manual

EN
Factory Settings
Horns Arms
Elevator
Rudder
Ailerons
Control Horn and Servo Arm Settings
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the reccomended
settings, the AR636 gain values will need to be adjusted. Refer to
the Spektrum AR636 manual for adjustment of gain values.
Flap Installation
OPTIONAL
B
A
Fig. B
Fig. A
Fig. C
D
C
1/2 or Takeoff Full
Flap Down 12mm down 25mm down
IMPORTANT: If desired, install the optional fl aps before installing the wing.
1. Install a tube on each clevis (Fig. A).
2. Connect the fl ap servo (PKZ1090, sold separately) to a servo extension
(PKZ5403, sold separately).
3. Connect the servo extension to the AUX1 port of the receiver.
4. Power on the transmitter and move the fl ap or gear switch to the up posi-
tion.
5. Install the servo arm on the servo at the angle shown (Fig. B).
6. Install the fl ap linkage in the outermost hole of the fl ap servo arm (Fig.B).
7. Install the fl ap servo (A) in the pocket (B) using hot glue or
double-sided tape.
8. Attach the clevises to the fl ap torque rods as shown (Fig. C).
9. On both fl aps, carefully cut a small amount of foam at the fl ap hinge (C)
and wing root (D) so the fl aps move freely (see illustration).
10. Do a control test of the fl aps using your aircraft and transmitter. Make sure
both fl aps are symmetrical while they are retracted and extended.
More control throw Less control throw
After fl ying, you may choose to adjust the linkage positions for the
desired control response. See the table below.
8