Manual

TDM Installation

Parr Instrument Company

Keys command:

1. Press “SET” to select

2. Press return key move to next operation mode

3. Up/Down arrow keys to adjust value or select type

Main Screen: SP = 0

Press return key and release

Press and hold down “SET” for 5-sec

* RTU if using Specview

** 8 if using Specview

Factory Default Settings

TDM Module

Operation Mode Select type/value Comment

r-S Run Run/Stop

SP 0 Decimal point position

LoC OFF Lock mode (lock all keys or only up/down arrow able to use)

Out1 - (read-only) Motor output %

Operation Mode Select type/value Comment

InPt v5 Input type (v5 = 0-5V, v10 = 0-10V, nA0 = 0-20mA, nA4 =

4-20mA, nV =0-50mV)

tP-H 2206 Upper-limit range

tP-L 0 Lower-limit temperature range

CTRL PID Control mode (ON/OFF, MANUAL, PID and PID PROG)

S-HC Heat Heat/Cool control

ALA1 0 Alarm mode

SALA OFF System alarm

CoSH ON Communication write function that able to use set point from

software

C-S1 ASCII* Format type

C-no 2 Communication address

bPS 9600 Communication baud rate

Len 7** Data length setting

PrtY Even Parity bit setting

StoP 1 Stop bit setting