Installation Guide

Installation & Operating Instructions for the
F4503
Parrotuncle Owner’s Installation ,Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
Parrotuncle Lighting, 218 Black Tie Lane, Chapel Hill, NC www.parrotuncle.com
Parrot Uncle YOU CAN BE SURE OF are trademarks of Eileen Grays LLC. Used under license by Eileen Grays LLC. All rights reserved. Made in China
Safety Cable Installation
For Canadian installation and for USA fan and light kit combinations over 35 lbs, the safety cable must be installed into the house structure beams. Make sure that when the safety cable is fully
extended the lead wires are longer than the cable and no stress is placed on the lead wires. Note: If Installing The Secondary Support Safety Cable in the U.S., Do Not Remove Knockouts In The
Outlet Box.
USING YOUR CEILING FAN
REMOTECONTROL
Turn on the power and check the operationof the fan
1 –Fan Shutdown
2 – Speed Controlle
3 – Lamp Switch
4 -Timer (2H,4H,8H)
Changing the Downrod (Optional)
NOTE: Your fan comes with a 4”(10cm) downrod attached to the hanger ball. In addition, a 10”(25cm)
downrod has been provided to be used in case the ceiling is lower. In this case, perform the following
steps for correct installation:
1. Remove the hanger ball from downrod by loosening the setscrew at the top of the downrod which
holds the hanger ball to the downrod.
2. Slide the hanger ball down the downrod and remove the support pin.
3. Insert the support pin in the holes at the top of the 4”(10cm) downrod and slide the hanger ball up the
4”(10cm) downrod. Make sure the support pin is properly seated in the grooves in the top of the hanger
ball.
4. Tighten the set crews firmly .
INSTALL THE DOWNROD
When hanging the Fan REMEMBER to turn off the power. Follow the steps below to hang your fan properly:
1) Remove the bolt, lock pin and set screws from the top of the housing assembly
2) Route wires exiting from the top of the fan motor through the coupling cover, decorative canopy cover, canopy and then through the ball / downrod.
3) Align the holes at the bottom of the downrod with the holes in the coupling on top of the top housing .
4) Carefully insert the Bolt through the holes in the Coupling and downrod. Be careful not to jam the Bolt against the wiring inside the downrod. Insert the locking pin through the hole near the end
of the Bolt until it snaps into its locked position.
5) Tighten two set screws on top of the fan housing firmly
INSTALLING THE FAN TO MOUNTING BRACKET ON CEILING
1. Install the hanger ball end of
downrod into mounting bracket
opening. Align (engage) slot on ball
with tab on mounting bracket.
Warning: Failure to align slot on ball
with tab may result in serious injury.
2. Slide the canopy up to ceiling and
align the keyhole slots on the canopy
with the preassembled screws on the
hanger bracket. Twist clockwise untill
it locks. Tighten the two screws
securely.
3. Attach the decorative canopy cover
to the bottom of the canopy by
pressing it until it locks.