Installation Guide

ManualsBrandsParrot Uncle ManualsCeiling Fans46-in Black LED Indoor/Outdoor Ceiling Fan with Remote (4-Blade)

Installation & Operating Instructions for the

F4601

Parrotuncle Owner’s Installation ,Manual

WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER

Parrotuncle Lighting, 218 Black Tie Lane, Chapel Hill, NC www.parrotuncle.com

Safety Cable Installation

For Canadian installation and for USA fan and light kit combinations over 35 lbs, the safety cable must be installed into the house structure beams. Make sure that when the safety cable is fully

extended the lead wires are longer than the cable and no stress is placed on the lead wires. Note: If Installing The Secondary Support Safety Cable in the U.S., Do Not Remove Knockouts In The

Outlet Box.

INSTALLING THE LIGHT KIT

1. Remove the 4 garnish nuts preassembled from the garnish screws on the base plate

2. Remove the plastic protective film from the light shade and route the wires exiting from the

bottom of the fan motor through the light shade.

3. Make wiring connections. Please refer to the section ‘MAKE THE ELECTRIC CONNECTION’

for the electric connection between fan motor and light kit.

4. Attach the light pan onto the base plate. Aligning the 4 holes on the light pan with the 4

preassembled garnish bolts on the base plate.Reinstall the 4 garnish nuts that removed in step

1. And tighten all nuts and screws securely

USING YOUR CEILING FAN

REMOTECONTROL

Turn on the power and check the

operationof the fan

1 –Fan Shutdown

2 – Speed Controlle

3 – Lamp Switch

4 -Timer (2H,4H,8H)

Changing the Downrod (Optional)

NOTE: Your fan comes with a 4”(10cm) downrod attached to the hanger ball. In addition, a 10”(25cm)

downrod has been provided to be used in case the ceiling is lower. In this case, perform the following

steps for correct installation:

1. Remove the hanger ball from downrod by loosening the setscrew at the top of the downrod which

holds the hanger ball to the downrod.

2. Slide the hanger ball down the downrod and remove the support pin.

3. Insert the support pin in the holes at the top of the 4”(10cm) downrod and slide the hanger ball up the

4”(10cm) downrod. Make sure the support pin is properly seated in the grooves in the top of the hanger

ball.

4. Tighten the set crews firmly .

INSTALL THE DOWNROD

When hanging the Fan REMEMBER to turn off the power. Follow the steps below to hang your fan properly:

1) Remove the bolt, lock pin and set screws from the top of the housing assembly

2) Route wires exiting from the top of the fan motor through the coupling cover, decorative canopy cover, canopy and then through the ball / downrod.

3) Align the holes at the bottom of the downrod with the holes in the coupling on top of the top housing .

4) Carefully insert the Bolt through the holes in the Coupling and downrod. Be careful not to jam the Bolt against the wiring inside the downrod. Insert the locking pin through the hole near the end

of the Bolt until it snaps into its locked position.

5) Tighten two set screws on top of the fan housing firmly

INSTALLING THE FAN TO MOUNTING BRACKET ON CEILING

1. Install the hanger ball end of downrod into mounting bracket opening. Align (engage) slot on ball with

tab on mounting bracket. Warning: Failure to align slot on ball with tab may result in serious injury.

2. Slide the canopy up to ceiling and align the keyhole slots on the canopy with the preassembled screws

on the hanger bracket. Twist clockwise untill it locks. Tighten the two screws securely.

3. Attach the decorative canopy cover to the bottom of the canopy by pressing it until it locks.