Installation Guide

Installation & Operating Instructions for the
F6225
Parrotuncle Owner’s Installation ,Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
Parrotuncle Lighting, 218 Black Tie Lane, Chapel Hill, NC www.parrotuncle.com
Parrot Uncle YOU CAN BE SURE OF are trademarks of Eileen Grays LLC. Used under license by Eileen Grays LLC. All rights reserved. Made in CHINA
REPAIRING THE FAN RECEIVER & REMOTE PAIRING
CODE SWITCH
1. CODE SWITCH: Codes are set by pushing dip switches up or down. It is imperative that the code
used for both transmitter and receiver is exactly the same, otherwise remote controller will not work.
Please note the code switch will enable you to operate a second remote controller independently. For
example, if you have two ceiling fans with 2 remote control units, set 2 different codes for each set of
transmitter/receivers. This means you can operate each ceiling fan independently.
2.
Your remote control is ready for use after battery installation(need 12V battery 1pc).
ON DIP
1234
ANTENNA
DIP SWITCH
TO OPEN BATTERY HOUSING
COVER BY PRESS DOWN AND
SLIDE OUT
RECEIVER
FUNCTIONS OF TRANSMITTER
: Press and release immediately to turn on or off the light.
Press and hold to dim or brighten lights to the desired level and
release. (Only for the tungsten bulb.)
Ceiling Fan Remote Control
Wiring Connection
TRANSMITTER
To install the Transmitter Wall
Mount Holder with two screws.