Instructions / Assembly

WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
F6225
Installation & Operating Instructions for the
Parrotuncle Owner's Installation ,Manual
5
down rod coupler
Remove the 2 screws in the down rod
coupler until the inside of the channel is
clear of the screw tip.
Remove and save the safety pin and
cotter pin on the end of the support rod
assembly.
cotter pin
safety pin
Downrod installation
canopy
coupling
cover
Washer
set screw
Place downrod assembly into canopy and coupling
cover. Feed motor wires though the downrod
assembly . Rotate downrod into downrod coupling.
Make sure to align hole in downrod with the hole in
downrod coupling. Install safety pin through
coupling and downrod. Place the washer and insert
cotter pin into safety pin until it snaps into place.
Tighten 2 set screws in coupling. Slide coupling
cover over the downrod coupling.
motor wires
downrod
cotter pin
safety pin
downrod hole
downrod coupling hole
downrod coupling