Data Sheet

2018/11/15 Particle Datasheets | Xenon datasheet
https://docs.particle.io/datasheets/mesh/xenon-datasheet/ 17/22
The Xenon contains highly sensitive electronic circuitry and is an Electrostatic Sensitive
Device (ESD). Handling Xenon without proper ESD protection may destroy or damage it
permanently. Proper ESD handling and packaging procedures must be applied
throughout the processing, handling and operation of any application that incorporates
Xenon. ESD precautions should be implemented on the application board where the
Xenon is mounted. Failure to observe these precautions can result in severe damage to
the Xenon!
There are four connectors on the Xenon that will get damaged with improper usage. The
JST connector on the circuit board, where you plug in the LiPo battery, is very durable but
the connector on the battery itself is not. When unplugging the battery, take extra
precaution to NOT pull the connector using the wires, but instead hold the plug at its base
to avoid putting stress on the wires. This can be tricky with bare hands - nose pliers are
your friend here.
The micro B USB connector on the Xenon is soldered on the PCB with large surface pads
as well as couple of through hole anchor points. Despite this reinforcement, it is very easy
to rip out the connector if too much stress is put on in the vertical direction.
Connectors