Product Info

Revision Date Author Comments
pre2 12 May 2020 RK Added partial dimensions
001 29 Jun 2020 RK First release
002 30 Jun 2020 RK CAN 5V is limited to 400 mA, not 500 mA
003 16 Jul 2020 RK Corrected M8 pinouts
004 06 Aug 2020 RK Corrected M8 pin numbering
005 09 Aug 2020 RK Updated VIN voltages
FCC:
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To comply with FCC’s RF radiation exposure limits for general population/uncontrolled exposure, this
device must be installed to provide a separation distance of at least 20cm from all persons.
WARNING: Any changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device must not be collocated or operating in conjunction with any other antenna or transmitter.
IC:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions:
this device may not cause interference.
this device must accept any interference, including interference that may cause undesired
operation of the device.